In daily use, intelligent swing gates may also have such problems due to frequent use or irregular maintenance or improper use for human reasons. It will be difficult for users to determine the cause by themselves, so technical maintenance by swing gate manufacturers is required. The staff is mobilized, and the user is paying attention! Do you know these secrets of the smart swing gate? Here is the secret of the manufacturer Beijing Cimo Luo.
1. Opening the door
After the smart swing gate is authorized, one door can be opened, but the other side cannot be opened.
Solution: Check whether the synchronization cable is connected properly. If it is connected, check again whether the control board that does not open the door has received a signal. If there is no signal, you need to check whether the cable has fallen off and plug it into the motherboard. Whether the line is plugged in properly.
2. The swing gate does not work when the power is on
Solution: Check whether the indicator light on the device is on and the motor starts normally. If it does not start normally, first check whether there is voltage output on the motor terminal. If the above checks are normal, it may be that the movement is stuck.
First, wire the door wing of the speed-pass door back into place, and then manually test. If the movement is smoother, the movement may be damaged and the movement needs to be repaired.
3. No response to the signal swing
Solution: Check whether the output voltage of the transformer is normal
Whether the fuse is fused
Check whether the motor connection wire is disconnected and whether the motor is damaged.
4. The direction of the indicator light is reversed, and an alarm appears when passing through
Solution: Check whether the control signal line of the main board of the swing gate is connected reversely, and try to exchange the signal line to be controlled
5. When the swing gate is closed, the swing gate can be opened manually
Solution: Check whether the movement is worn, whether the groove plate is damaged or the gap is too large, if there is a problem, ask the manufacturer to replace it in time.
6. After the swing gate is opened, the swing gate does not close
Solution: Check whether the infrared sensors on both sides of the swing gate are correct. Make sure that there is no problem with the main board. Pedestrians pass the inspection to see if the working light of the infrared sensor on the control main board is normal.
When using the smart swing gate, users should not wait until there is a problem to deal with it, just like car maintenance is the same, usually we also need to master some knowledge about the maintenance of pedestrian gates, which can also prevent problems in the later stages of the gates.
1. First of all, we must start with the correct use of the gates, especially when there are many people, it is strictly forbidden to squeeze or control the gates to avoid affecting the normal operation of the equipment.
2. Secondly, when the gate is not in use, it is forbidden to put any heavy objects on the equipment or shake the door manually.
3. Make selections when installing the gates for indoor and outdoor pedestrian passageways, and use special speed-pass gate equipment outdoors, which requires water, dust, and sunlight resistance.
4. It is forbidden to stay in the swing gate channel when using traffic.
5. Regularly wipe, fasten parts and other maintenance equipment
Are the above six and five points clear? We are waiting for you to share more detailed knowledge about turnstiles.
The small secrets of the use and maintenance of the smart swing gate are divided into six and five points.
Graphite Molds,High Purity Graphite,Medium Grain Graphite,High Strength Graphite Block
Henan Carbons New Material Technology Co., Ltd. , https://www.hncarbons.com