| Home>Bearing knowledge>Analysis: Reasons for motor bearing overheating |
Analysis: Reasons for motor bearing overheating
Source: China Bearing Network Time: 2014-01-20
| /*250*250 was created on 2017/12/25*/ var cpro_id = 'u3171089'; |
2. The rolling bearing grease is too little, too much or has iron scraps and other impurities. The bearing grease capacity should not exceed 70% of the total volume; those with impurities should be replaced.
3. The shaft and the bearing cooperate too tightly or too loosely. When it is too tight, it should be ground from the head; when it is too loose, it should be set to the shaft.
4. The bearing and the end cap cooperate too tightly or too loosely. The bearing chamber is processed when it is too tight; when it is too loose, the steel sleeve is set in the end cover.
5. The two caps or bearing caps of the motor are not properly installed. Install the end cap or bearing cap into the flat; tighten the screws.
6. The belt is too tight or the coupling is not properly installed. Adjust the belt tension; proofread the coupling.
7, the sliding bearing lubricant is too little, there are impurities or oil ring stuck. Should be refueling, new oil; repair or replace the oil ring.
Recommend to friends comments close window
| Bearing related knowledge |
| Talking about Radiator Bearing Method Classification Oil Bearings Railway Bearings Quantitative Grease Machine SKF Bearing's “Appearance View Strategy†Analysis of the Causes of Failure of NSK Tapered Roller Bearings |
This article links to http://
Please indicate the bearing network http://
Previous: Common terms and definitions of bearings (1)
Next: How to choose the clearance of imported bearings
Monomers Oligomers,Cas 108-45-2,M-Phenylenediamin In Stock,108-45-2 99%
Henan Tianfu Chemical Co.,Ltd , https://www.tianfuchem.com