Cryogenic turning

For the processing of slender shaft workpieces, sheet workpieces, stainless steel, rubber, thermoplastics, etc., if low temperature turning is used, satisfactory results can be obtained. Electric low temperature turning is a method of freezing the workpiece to a cold plate by using liquid film ice liquid to reduce the temperature of the workpiece to below -20 °C. As an accessory to the ordinary lathe, the cold plate can be loaded and unloaded at any time without changing the structure of the original lathe.

HDPE Pre-applied Waterproofing Membrane

SRD HDPE Pre-applied Waterproofing Membrane has three layers. HDPE is the main waterproof layer, and there is one protective layer (for an environmental change), and one isolated layer. It has a self-adhesive overlap edge on the long side. SRD HDPE waterproof membrane is suitable for most below-ground structure projects.The wet bonding technique: After moisture curing reaction between cement slurry and high polymer, the membrane and the structural layer will be firmly bonded, which will improve the reliability of the waterproof layer.
Great puncture resistance and shock resistance: It can withstand the working load and the attack of the reinforcement cage, and doesn't need special protections.
Great puncture resistance and shock resistance: It can withstand the working load and the attack of the reinforcement cage, and doesn't need special protections.
Outstanding chemical resistance: SRD HDPE Membrane has great resistibility towards the alkali water from the concrete, home scrap will not affect it.
Minimal surface treatment: Doesn't need oil or heat to dry the wet substrate, with no volatile substance.

Hdpe Pre-Laid Anti-Stick Waterproofing Membrane,Self Adhesive Waterproofing Membrane,Waterproofing Membrane Self Adhesive,Self Adhered Waterproofing Membrane

Suzhou Smart Building New Materials Co., Ltd. , https://www.srdwaterproofing.com