How to do maintenance of the slitter

1. Put butter and move left and right on the surface of discharge rack and sliding bearing (every three days);
2. Put the grease on the surface of the slide bearing at the discharge shaft pressure plate with a grease gun (once a week, clean the fuel before refueling);
3. Lubricate the brake joint and move it back and forth several times (three times a week, pay attention to cleaning);
4. Adjust the rollers of the slitter and adjust the part to add oil (three times a week, pay attention to cleaning);
5. Fill the butter at the adjusting position of the knife (worm and worm) (three times a week, pay attention to cleaning);
6. Add lubricant to the clutch shaft (three times a week, pay attention to cleaning);
7. Scrap up the support shaft and add butter. Move the mechanism several times (three times a week, pay attention to cleaning);
8. The drive shaft of the screwless screw set is filled with butter and moved several times (three times a week, pay attention to cleaning);
9, slitting machine to seal the roll of each Cylinder to clean, fish eyeballs add lubricant (three times a week, pay attention to clean).

Curtain Rings

Engraved Claddagh Rings,Shower Curtain Eyelet Rings,Curtain Rods

Botai Window Decoration Material Co., Ltd. , http://www.wlcurtainrod.com

This entry was posted in on